Find the perfect match for your A11 pen, a cartridge to treat your skin condition and concerns. The 12-Pin Microneedle Cartridge is specially designed to be effective in reducing the appearance of wrinkles and fine lines.

The 12-Pin Microneedle Cartridge creates microscopic punctures in the skin to stimulate collagen production and help reduce visible ageing signs.

Using the 12-Pin Microneedle Cartridges you can expect benefits, such as:

Reduced deep wrinkles and fine lines
Improved skin textures
Firm loose and sagging skin
Reduced acne scarring visibility
Reduced hyperpigmentation
Help with sun damage
Even-out skin tone

Upgraded features to suit the new Dr. Pen A11 Microneedling Pen

Newly adopted wavy contact edge to help with better skincare product absorption
Newly built three snap connector to help with performance and protection of the device machine
Easily paired with Dr. Pen A11 Microneedling Pen
High-quality stainless steel for the gauge
Maximum depth of 2.5mm

What’s Included

10x pack of 12-pin Microneedle Cartridges for Dr. Pen A11 Microneedling Pen

DO NOT USE

One cartridge more than once for safety and hygiene reasons
On open wounds
On broken skin
On active acne
Or continue to use if irritation occurs

Important: Microneedling cartridges must be sterilised before each use to ensure the treatment is safe and hygienic. It is essential to follow these steps carefully to ensure that the microneedling cartridges are properly sterilised. Here are the steps to sterilise microneedling cartridges:

First, ensure that you have all the necessary equipment for sterilisation; gloves, isopropyl alcohol solution (70% or above) and a clean container to hold the solution.
Put on your gloves to avoid contaminating the cartridges during the sterilisation process.
Check on your cartridge; ensure the needles are in perfect condition (i.e. not bending) and remove any debris.
Pour enough alcohol solution into the container and dip the cartridge needle into a sterilisation container, then soak for a couple of minutes.
If you have alcohol solution in a spray model, you can spray it towards the needle head of the cartridge.
Once the sterilisation is complete, allow the cartridge to air dry before using it.
Finally, your cartridge is ready for use.

How to Use

Remove the sterile cover on the top of the cartridge
After that, connect the cartridge to the Dr. Pen A11 Microneedling Pen
After double-cleansing the face, put Femvy Hyaluronic Acid serum in the desired small areas for treatment
Turn the pen on, and set the gauge’s depth and pen’s speed according to your preferred specific treatment
Slowly start the treatment in small areas
The recommended pattern to use is cross-hatch and use only light pressure to ensure not to drag/pull the skin.
Safely dispose of your microneedling cartridge after one treatment

Usage

Schedule your microneedling treatment once every 4-6 weeks

Disclaimer

Please speak with your doctor before purchasing any Dr Pen products. The content on this site is not intended to substitute for the advice of a qualified physician, pharmacist, or other licensed healthcare professional. The products may have additional information and instructions on or inside the packaging that you should carefully read and follow. Contact your healthcare provider immediately if you suspect that you have a medical problem. This product may not have been evaluated by the Food and Drug Administration and is not intended to diagnose, treat, cure, or prevent any disease or health condition. For any concerns or questions, please contact your GP or dermatologist.

A11 Cartridges

24 Pin Replacement Cartridges for Dr.Pen A11 (10 Pack)

Nano Round Replacement Cartridges for Dr.Pen A11 (10 Pack)

18 Pin Replacement Cartridges for Dr.Pen A11 (10 Pack)

36 Pin Replacement Cartridges for Dr.Pen A11 (10 Pack)

42 Pin Replacement Cartridges for Dr.Pen A11 (10 Pack)

12 Pin Replacement Cartridges for Dr. Pen A11 (10 Pack)

Nano Square Replacement Cartridges for Dr.Pen A11 (10 Pack)